All insights
Practical Guides4 min read

Six signs an instrument needs calibrating before its due date

A due date is a plan, not a guarantee. These are the warning signs that an instrument should come in early, whatever its label says.

A calibration interval is a forecast: based on history and specifications, the instrument is expected to stay in tolerance until its next due date. Most of the time that forecast holds. But some events make it unreliable, and when they happen, the instrument should be checked early rather than trusted until the label expires.

1. It has been dropped or knocked

Mechanical shock can shift internal components, crack solder joints, damage connectors and upset oscillators. A handheld meter that has fallen from a ladder or a scope that has slid off a trolley may look fine and still be measuring incorrectly. After any significant impact, check it against a known reference at minimum, and send it in if there is any doubt.

2. It has been overloaded

Applying a voltage, current or RF power beyond an instrument’s rated input can damage protection components, shunts, attenuators and front-end mixers. Blown fuses are an obvious sign, but damage can also be partial: a slightly degraded input that still gives a plausible reading. Any instrument that has been overloaded should be verified before it is trusted again.

3. It disagrees with another instrument

If two calibrated instruments measuring the same quantity disagree by more than their combined specifications, at least one of them is wrong. Do not average them or pick the one you prefer. Take both out of service until you know which one is at fault.

4. It has been exposed to extreme conditions

Prolonged heat, as in a parked vehicle during a UAE summer, condensation, water ingress or heavy dust exposure can all affect calibration. So can storage outside the manufacturer’s rated conditions for an extended period.

5. It has been repaired or had firmware updated

Any repair that touches the measurement path, from replacing an input connector to swapping a circuit board, invalidates the existing calibration. Firmware updates can also change measurement algorithms or calibration constants. After either, the instrument should be calibrated before returning to service.

6. Its readings are behaving strangely

Readings that drift during a measurement, change when the instrument is tapped, take unusually long to settle, or vary with how leads are positioned are all symptoms worth investigating. Check leads, connectors and batteries first; if the behaviour persists, have the instrument checked.

What to do in the meantime

If one of these events occurs:

  1. Label the instrument as suspect and take it out of service.
  2. Record what happened, when, and what the instrument was used for since its last known-good check.
  3. Send it for calibration, asking specifically for as-found data so you can assess any impact on past measurements.

Unplanned calibrations are an inconvenience. Discovering at the next scheduled calibration that an instrument has been wrong for six months is far worse. If you are not sure whether an event warrants an early calibration, call us and describe what happened. We would much rather have that conversation than read about it later in an out-of-tolerance report.

Start a calibration

Your next calibration is due sooner than you think.

Send us your instrument list and we will come back within one working day with a fixed quote, turnaround date and collection slot.